


Comparison of Grate Furnace Incineration Treatment Technology and Pyrolysis Gasification Treatment Technology | ||
Compare Content | Grate Furnace | Pyrolysis Gasifier |
Incineration Mechanism | The Garbage Is Directly Burned, The Combustion Temperature Is 800~1000°C, The Incineration Mechanism Is General | Using Two-Stage Treatment, The Garbage Is Now Pyrolyzed And Gasified, And Then Small-Molecule Combustible Gas Is Burned. The Combustion Temperature Is 850~1100℃. The Incineration Mechanism Is Advanced. |
Furnace Structure And Grate Material | The Structure Is Complex And The Shape Is Large; The Grate Works Under High Temperature, And The Requirements For The Grate Material Are High | The Structure Is Relatively Simple And Compact; The Grate Works In A Low Temperature State, And The Requirements For The Grate Material Are Low |
Types Of Garbage | Dispose Of Domestic Waste | It Can Process Domestic Waste, Industrial Waste, And Hazardous Waste With High Calorific Value (Including Medical Waste) |
Area (300t/D) | 40-50 Acres Higher | 30-40 Acres Lower |
Operating Cost Fly Ash Emissions | Fly Ash Discharges A Lot, Accounting For About 5% Of The Total Garbage | Fly Ash Emission Is Low, Accounting For About 1% Of The Total Garbage, Which Is Environmentally Friendly |
Acidic Substance And Dust Emission | The Original Value Of Acidic Substances Such As So2 And Nox Is Relatively High; The Dust Emission Concentration Is 6000~8000mg/Nm3 | The Original Value Of Acidic Substances Such As So2 And Nox Is Relatively Low: The Dust Emission Concentration Is ≤3000mg/Nm3 |
Plant Environment | It Is Difficult To Control The Environment In The Plant Area. The Incinerator Workshop Has A Certain Amount Of Bottom Ash And Leachate, Noise, And Odor Pollution. | The Factory Environment Is Well Controlled, And The Bottom Ash, Noise, And Odor Pollution In The Workshop Are Low |
-
Waste Gasification Power Plant
Waste gasification power plant: capacity from 1000kw to 6000kw, modular design, several modular for big capacity.
Views More -
Waste Gasifier
Waste Gasifier: single furnace treatment capacity up to 50 ton/day, it can treat household waste, industrial waste and medical waste.
Views More -
Biomass Gasification Power Plant
Biomass gasification power plant: capacity from 200kw to 3000kw, 1kg woody biomass generate 1kw electricity, 1kw woody biomass produce 2-3m3/h syngas, syngas heat value 1100-1500kcal/m3.
Views More -
Biomass Gasifier
Applicable raw materials: a wide range of raw materials, such as straw, wood chips, rice husk, palm shell, bagasse and other agricultural and forestry wastes
particle size: 30-50mm, water content: less than 20%Views More





HyCO Plants - Linde Gas
For hydrogen or chemical plants, e.g. SynGas or HyCO (Hydrogen - Carbon Monoxide) Plants, Linde Engineering Division is a leading technology partner for plant engineering and construction worldwide. Global success is built on extensive process engineering expertise in the planning, project development and construction of turnkey industrial plants.
Wood Gas or Syngas Gasification of Bio-Mass | Electronics Forums
Oct 22, 2009 · Well I finally got down to bio-mass gasification in my read queue, Jim just mentioned it and I think I first heard of it through Ulysses. An interesting process and another time tested DIY project intended for
Biomass Gasifier Power System in Baking Paint Equipment-Haiqi
It Can Process Domestic Waste, Industrial Waste, And Hazardous Waste With High Calorific Value (Including Medical Waste) Area (300t/D) 40-50 Acres Higher: 30-40 Acres Lower: Operating Cost Fly Ash Emissions: Fly Ash Discharges A Lot, Accounting For About 5% Of The Total Garbage
What is Electrocoating? - Products Finishing
Feb 21, 2011 · Electrocoating is a process by which electrically charged particles are deposited out of a water suspension to coat a conductive part. During the electrocoat process, paint is applied to a part at a certain film thickness, which is regulated by the amount of voltage applied. The deposition is self-limiting and slows down as the applied coating
The CO2 economy: Review of CO2 capture and - ScienceDirect
Feb 01, 2018 · Pre-combustion is related to new integrated gasification technologies for produce syngas production and hydrogen firing in the cement kiln without CO 2 capture from the calcination process. On the other hand, post-combustion capture has many retroffitting options with lower costs and higher emission reduction, while the replacement with new
Production of Hydrogen - Stanford University
ITM Hydrogen/Syngas: A Revolutionary Technology Using Ceramic Membranes zIon Transport Membranes (ITM) – Non-porous multi-component ceramic membranes – High oxygen flux and high selectivity for oxygen – Operate at high temperatures, typically over 700 °C zITM Hydrogen/Syngas combines air separation and methane
energy generation from domestic/industrial/medical waste
In this process, water vapor, free oxygen, or bound oxygen reacts with the carbon in the fuel to form a combustible gas. Biomass gasification process is more complex and the gasification reaction conditions are also different. syngas technologies in Baking Paint Equipment-Haiqi Biomass Biomass gasification power plant: capacity from 200kw to
An Introduction to CO2 Separation and Capture Technologies
allows for a CO 2 removal process (e.g., a physical solvent process like Selexsol ) that is much less energy intensive than the MEA process because capture takes place from the high pressure syngas as opposed to the atmospheric pressure flue gas. A similar process is available for natural gas, where the syngas is formed by steam reforming of
6.1. Commercial Technologies for Syngas Cleanup | netl.doe.gov
6.1. Commercial Technologies for Syngas Cleanup. Synthesis gas (syngas) leaving the reactor is at high temperature; typically 2,500°F to 2,800°F for an entrained-flow gasifier. Recovery of heat from the syngas is essential for attaining process efficiency. Heat recovery systems can reclaim a significant portion (5-25%) of the energy contained
A Gas-Steam Combined Cycle Powered by Syngas Derived from
Jan 01, 2013 · Abstract. In this paper, an innovative power plant, constituted by a gas turbine in combined-cycle fuelled by a synthesis gas (or syngas), produced in a local biomass gasifier, is analyzed. The plant is integrated with an external combustion sys- tem, fed by cellulosic biomass, connected to a heat exchanger able to increase the air temperature
Chapter 4 MATERIAL BALANCES AND APPLICATIONS
process system; it can be applied to the total mass of this material or to any molecular or atomic species involved in the process. The general balance equation may be simplified according to the process at hand. For example, by definition, the accumulation term for steady-state continuous process is zero. Thus the above equation becomes:
Hydrogen Applications for Chemical Production - Linde Gas
Mixtures of hydrogen (H 2 ) and carbon monoxide (CO), known as syngas, are fed to processes for large scale production of methanol and various so-called oxo products like higher alcohols and aldehydes. Among other applications is e. g. the elimination of oxygen from boiler feed water. Main processes for hydrogen production: Steam reforming of
Bakery Equipment Coatings & Maintenance | AFT Fluorotec
AFT Fluorotec have a broad range of experience in designing and manufacturing RCD seals for the oil & gas industry. PTFE Seals. From back up rings and mining seals to piston seals and o rings, we offer a wide range of sealing products machined from polytetrafluoroethylene (PTFE). VICTREX PEEK Seals.
advantage of biomass in Baking Paint Equipment-Haiqi Biomass
It Can Process Domestic Waste, Industrial Waste, And Hazardous Waste With High Calorific Value (Including Medical Waste) Area (300t/D) 40-50 Acres Higher: 30-40 Acres Lower: Operating Cost Fly Ash Emissions: Fly Ash Discharges A Lot, Accounting For About 5% Of The Total Garbage
Syngas Processing - RTI
Employing process technologies that remove contaminants and develop catalysts for converting syngas into fuels. Over the past two decades, our work in advanced gasification and syngas research has led to the development of novel, sorbent-based syngas cleanup technologies. We pinpoint contaminants that impair catalyst performance in pursuit of more efficient transportation fuels, focusing on warm desulfurization, trace contaminant removal, direct sulfur recovery, syngas cleaning and
-
Rotary Automatic Slag Burner
Applicable raw materials: wood chips, straw briquette, bark, building templates, pellets
Diameter: <10cm Moisture content: <15% -
Chain Grate Semi-Gasification Burner
Applicable raw materials: wood chips, straw briquette, bark, building templates, pellets
Diameter: <10cm Moisture content: <15% -
Waste Gasification Power Plant
Waste gasification power plant: capacity from 1000kw to 6000kw, modular design, several modular for big capacity.
-
Waste Gasifier
Waste Gasifier: single furnace treatment capacity up to 50 ton/day, it can treat household waste, industrial waste and medical waste.
-
Biomass Gasification Power Plant
Biomass gasification power plant: capacity from 200kw to 3000kw, 1kg woody biomass generate 1kw electricity, 1kw woody biomass produce 2-3m3/h syngas, syngas heat value 1100-1500kcal/m3.
-
Biomass Gasifier
Applicable raw materials: a wide range of raw materials, such as straw, wood chips, rice husk, palm shell, bagasse and other agricultural and forestry wastes
particle size: 30-50mm, water content: less than 20%